Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
-
Re: Single Point Ground
No matter how much we try and eliminate ground loops, it's nearly impossible to do so. With most of our equipment, ground loops are an indispensable part of our stations. It's more importan…1 -
Re: Key Clicks Video
Eric, I'm not a Flex alpha tester, but I'll be happy to make oscilloscope timing measurements similar to what I posted earlier if that's of any interest to you. Paul, W9AC1 -
Re: 6300 Key Clicks
John, There's still a problem in that the keyed waveform used to be fine with CW Delay and Tx Delay set to zero for QSK operation -- at least on the 6700. The trialing edge of the waveform is no…1 -
Re: Ssdr TX-Delay Video
Al, Those settings would normally be fine. Using any any modern amp with either PIN or vacuum relay switching -- and/or perhaps a reed relay on the input, a TX Delay setting of 0 should work well. Ba…1 -
Re: CW-U and CW-L
Steve, That results in extremely thin recovered audio with the wider CW filter settings -- and would undermine the goal. I think you had it right the first time when you state: "-500 Hz to 1500 …1
